Say your waist circumference is 100cm, then the front and back part should be 66cm wide. This is the best online picture set and I had to sing its praises, thank you! Share it with us!
Remember that pattern is inclined rising only on one side for the back. Final piece will look like this. Fold in the tight side towards the center , creating an angled crease along the length of your leg. Did you make this project? Since I have thighs that touch, shorts crawl up and bunch in the crotch and wearing nothing under summer dresses causes chafing. I guess there must be some word for it, but I don't know, may be flat seam?
I'm a sewer, but I guess it's because I'm used to using a commercial sewing pattern, but this doesn't compute for me. Pull the string across your body and hold both the string and centered folds with that same arm.
If you prefer, you can tuck some of the cloth under the knot so that you can adjust the waistline easily.
Reply 8 years ago on Introduction.
Jensen Oct 28, 2017. Are these the ties at the waist? Add the rough part to the pants and the soft to the ribbon. I usually think of the hem as being at the bottom.
For instance, in step 2 you refer to a "circular space inside the pants". These are similar to "Thai Fisherman Pants" at least in how they look, but those don't wrap around so much as they do fold-around, and they are seamed entirely.
AC Amy Carlisle Jun 10, 2016. Ok, Got the four ties. Turn under the top waist edge to the inside and stitch.
Get hold of the strap ends from the back to the front. Stitch in place. If you use the right fabric it's even better than shorts! Make the waist tie. The front and back are made half from the upper piece of cloth and half from the lower, look at the second picture to see what I mean. Was trying to figure out how this pants thing was done for a while now.