To find a dealer, enter your zip or postal code below Find a Dealer International Dealers. Just got my Kreg5. Seems to work fine, but as mentioned below, a jig to square the pieces sounds easier and repeatable.
Started by Lupe in Beginners' Zone. I really like my K4 pocket hole jig but I had a big cabinet project coming up so I wanted a way to clamp the boards to it faster than the toggle clamp alowed.
I had seen some other people make pocket hole jigs with pneumatic cylinders in place of… Continue. All Discussions My Discussions Add. I had seen some other people make pocket hole jigs with pneumatic cylinders in place of… Continue Tags: Join Us On: CST Email Us.
The pin on this one only fits the regular sized pocket holes. Place a clamp on each end to hold the wood while you drive screws in the remaining pocket holes.
Posted by Glenn Revheim on April 5, 2018 at 5: I have built many kitchens and finally decided to buy the Foreman, because my latest kitchen consisted of 28 cabinets and I was over my hand hurting from all the drilling, moving the clamp etc. I could not wait to get to my shop and build shelves and bookcases. Call 1-800-447-8638 Monday - Friday 8: Place in corner and clamp the brace to get 90 degree then jig clamp it.
Then I used it for a park bench. Very helpful. Find a Dealer.
Call 1-800-447-8638 Monday - Friday 8: Any plans available? IMO, Kreg has a real winner in this clamp. Also excellent quality product, Kreg you did it again!
I bought two of these clamps through Amazon quite recently. Gary , If I may , a " little " drop of oil on the adjusting knob , and wha-la...
Add to Cart. Write a Review. Two Kreg corner clamps hold a T-Joint piece firmly at a 90 degree angle allowing it to be placed virtually anywhere.