How to cut corner round molding

How to Cut Quarter Round Molding

Both trim moldings start out as long round dowels that are then rip-cut into their respective shapes. Steady the miter box with your non-dominant hand, and hold the saw in your dominant hand.

How To Cut Quarter Rounds for a 45 Degree Angle

Quarter round will always be cut at an angle, usually 45 degrees. For the piece that will terminate in a "return," lay down a piece of molding that is several inches longer than the length you need. Woodworking Print Edit Send fan mail to authors. Place your thumbnail exactly on the line and draw the handsaw toward you to begin the initial cut. The cuts for quarter round molding are very minor. This tool will automatically "set" or recess small finish nails, and can greatly speed up your work.

Carefully, and slowly, begin cutting until a deep groove is established, and then finish the cut quickly. Return pieces are also found on baseboards and crown molding. Cut the Return Piece. Let the finish dry completely before proceeding to installation. You should end up with an end cap that is flat on one side and a 45-degree angle on the other side. Tools and Materials Needed Quarter round or shoe molding.

Article Info This article was co-authored by our trained team of editors and researchers who validated it for accuracy and comprehensiveness.

how to cut corner round molding

If the match between the length and scrap pieces matches correctly, use the piece of scrap molding to cut the next adjoining length of molding. Read More. Continue to 2 of 13 below. Mark each piece of molding with a light, straight line through the use of a tri-square.

how to cut corner round molding

Thanks for letting us know. These joint pieces should fit together to form a flat line against the wall.

How to Install Shoe Molding or Quarter-Round Moldings

Quarter round is available at most home improvement stores. Do not glue the wall side or floor side of the return piece. Always exercise caution when using a saw. Most corners will be 90-degree angles. It is considered the crowning touch to subtly dress up the rooms in your home. Continue to 11 of 13 below.

how to cut corner round molding

In this Article: Hold the nailer close to horizontal, but angled slightly downward. If not, cut a new piece.